PB44Z Post Base 4x4

FOR 4X4 INSTALLATION/ZMAX GALVANIZED / NOT RECOMMENDED FOR NON-TOP SUPPORTED INSTALLATION/12 GAUGE / SET RIGHT INTO CONCRETE/(12) 16d NAILS / HOT DIPPED GALVANIZED FASTENERS REQUIRED

Simpson PB44Z Post Base with ZMax Coating to anchor a 4 x 4 post to concrete prior to pouring

Simpson ABA44Z 4x4 Adjustable Post Base - Zmax Finish

Simpson PB44Z Post Base with ZMax Coating to anchor a 4 x 4 post to concrete prior to pouring

Post and column bases secure the bottom of posts or columns to concrete and are perfect for decks or patio covers. Models are available for attaching

PB ZMAX Galvanized Non-Standoff Post Base for 4x4 Nominal Lumber

Simpson Strong-Tie - ABW44Z - ZMax 2.25 in. H x 3.56 in. W 16 Ga. Galvanized Steel Post Base

Simpson Strong-Tie ABA44Z - ZMAX Galvanized Adjustable Standoff Post Base for 4x4 : Industrial & Scientific

Post Bases Outdoor Supply Hardware

Simpson 4X4 Z PBS44AZ Strong-Tie Standoff Post Base

Simpson Strong Tie PB44Z Zmax Galvanized 12-Gauge 4x4 Post Base 10-per Box DSVI36

Simpson Strong-Tie PB ZMAX Galvanized Non-Standoff Post Base for 6x6 Nominal Lumber PB66Z - The Home Depot

The PB base embeds in wet concrete after pour and is made to install flush with the concrete surface. This connector was designed to help resist upload forces. Holes are provided for installation with 16d commons. A 2 inch minimum side cover is required to obtain the full load. Post bases do not provide adequate resistance to prevent members from rotating about the base and therefore are not recommended for non top-supported installations (such as fences or carports). 12-gauge galvanized steel.

Simpson PB44Z Strong-Tie 4 x 4 Post Base, Z-Max Finish

Simpson Strong-Tie PBS 4-in x 4-in Zmax Wood To Concrete (Cast In Place) Base in the Base & Cap Hardware department at

Simpson Strong-Tie PB44Z 4 x 4-Inch Post Base Zmax 10 Pk

4x4 Ironwood Post Base - OZCO Building Products

Simpson Strong-Tie PB44 4 x 4-Inch Post Base 10 Pk - Tool Expo